Lantronix SecureLinx Spider Podręcznik Użytkownika Pobierz pdf (Strona 57)

7: Interfaces

SecureLinx Spider/SpiderDuo User Guide 57

3. Do one of the following:

a. Click Save to save settings.

b. Click Reset to Defaults to restore system defaults.

c. Click Reset to restore original settings.

KVM Console Settings

The Remote Console window into the target system has settings that may be changed for the way

each individual user interacts with the Spider. When a user is created by copying from an existing

user, the Remote Console settings will be copied as well. You can change these settings on the

Interfaces > KVM Console Settings page. Note that if you are using the Spider View application,

these settings do not apply; see the Spider View User Guide for further information.

Modem (Spider Only) Connect to the Spider with a dial-up or ISDN connection, using PPP.

Essentially, the Spider acts as an ISP that you dial in to. The client system

will need to be set up accordingly, for example using the Windows Network

Connection Wizard. Change the following parameters as necessary:

 Serial Line Speed: Most modems support 115200 bps.

 Modem Init String: The initialization string sent out to set up the

modem. If you have a special modem or are going through a PBX

requiring an access sequence, you may modify the string. Consult the

modem’s manual on the AT command syntax.

 Modem server IP addresses: As part of the PPP handshake, IP

addresses are assigned to the remote device.

 Modem client IP address: IP address assigned to the Spider.

Passthrough Access to

serial port 1 via Telnet/

SSH

The serial port may be used to connect to the target server’s COM port for

integrated access to command line functions or used to control a serial-

interfaced peripheral. Telnet and SSH are network protocols that enable a

tunnel from the client system over the network to the Spider’s serial port.

Once the port is set up, it may be accessed through the web interface at the

Telnet Console window, or using a Telnet/SSH client to connect directly.

Set the following parameters to match connected equipment:

 Speed: The speed with which the device port exchanges data with the

attached serial device. From the drop-down list, select the baud rate.

Most devices use 9600 for the administration port, so the device port

defaults to this value. Check the equipment settings and documentation

for the proper baud rate.

 Data bits: Number of data bits used to transmit a character. From the

drop-down list, select the number of data bits. The default is 8 data bits.

 Parity: Parity checking is a rudimentary method of detecting simple,

single-bit errors. From the drop-down list, select the parity. The default

is none.

 Stop Bits: The number of stop bit(s) used to indicate that a byte of data

has been transmitted. From the drop-down list, select the number of

stop bits. The default is 1.

 Flow Control: A method of preventing buffer overflow and loss of data.

The available methods include none, software (xon/xoff), and hardware

(RTS/CTS). The default is none.

Table 7-7 Serial Port Settings (continued)

Field Description

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 132 133

Komentarze do niniejszej Instrukcji

Brak uwag

Lantronix SecureLinx Spider Podręcznik Użytkownika Strona 57

Komentarze do niniejszej Instrukcji