Lantronix Computer Hardware 900-581 Instrukcja Użytkownika Pobierz pdf (Strona 190)

5: Commands and Levels

debugging level debug

Sets the WLAN debugging level to Debug.

debugging level dump

Sets the WLAN debugging level to Dump, the most verbose op-

tion.

debugging level error

Sets the WLAN debugging level to Error, which shows only errors.

debugging level info

Sets the WLAN debugging level to Info.

debugging level warning

Sets the WLAN debugging level to Warning.

default active channel scan time

Restores the default active channel scan time.

default debugging level

Sets the WLAN debugging level to its default value, Info.

default out of range scan interval

Restores the default value to the out-of-range scan interval (30

sec).

default passive channel scan time

Restores the default passive channel scan time.

default radio band selection

Sets the radio band selection to its default value, Dual.

default rssi delta

Restores the RSSI delta value to the default value (24 dBm).

exit

Exit back to interface configuration level

out of range scan interval <seconds>

This setting determines the interval (in seconds)

between scans for access points to which the unit might roam.

This setting only applies when roaming is enabled.

NOTE: The more frequent the scans, the greater the impact on

data throughput.

passive channel scan time <milliseconds>

Sets the passive channel scan time in milliseconds.

radio band selection 2.4 ghz only

Sets the radio band selection to 2.4 GHz Only.

radio band selection 5 ghz only

Sets the radio band selection to 5 GHz Only.

radio band selection dual

Sets the radio band selection to Dual.

roam status

Show roaming status

roaming disable

Disables roaming.

roaming enable

Enables roaming to other Access Points with the same SSID.

rssi delta <dBm>

Sets the RSSI delta value.

scan <ssid>

Scan the radio environment for networks.

show

Displays the current configuration.

show history

Displays the last 20 commands entered during the current CLI

session.

show wps information

Show the configuration received by wi-fi protected setup.

show wps information with secrets

Show the configuration received by wi-fi protected setup with se-

crets.

show wps status

Show status of WPS operation.

start wps

Starts wi-fi protected setup operation.

status

Show link status

wlan watchdog disable

Disables the WLAN Watchdog.

wlan watchdog enable

Enables the WLAN Watchdog.

write

Stores the current configuration in permanent memory.

link (config-ethernet:eth0) level commands

clrscrn

Clears the screen.

default duplex

Restores the default duplex setting, which is auto.

default speed

Restores the default speed setting, which is auto-negotiate.

duplex auto

Sets duplex mode to auto.

duplex full

Sets duplex mode to full.

PremierWave EN Command Reference 190

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 211 212

Komentarze do niniejszej Instrukcji

Brak uwag

Lantronix Computer Hardware 900-581 Instrukcja Użytkownika Strona 190

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Lantronix Computer Hardware 900-581