Lantronix Computer Hardware 900-581 Instrukcja Użytkownika Pobierz pdf (Strona 57)

5: Commands and Levels

tx data rate maximum mcs1

Sets the data rate maximum to MCS1.

tx data rate maximum mcs2

Sets the data rate maximum to MCS2.

tx data rate maximum mcs3

Sets the data rate maximum to MCS3.

tx data rate maximum mcs4

Sets the data rate maximum to MCS4.

tx data rate maximum mcs5

Sets the data rate maximum to MCS5.

tx data rate maximum mcs6

Sets the data rate maximum to MCS6.

tx data rate maximum mcs7

Sets the data rate maximum to MCS7.

tx power maximum <dBm>

Sets the TX power maximum in dBm.

<dBm> = measure of power in decibels with respect to one

milliwatt.

write

Stores the current configuration in permanent memory.

arp (config-arp) level commands

add <IP address> <MAC address>

Adds an entry to the ARP table, mapping an IP address to a MAC

address.

<ip address> = IP address to be mapped.

<mac address> = MAC address in colon-separated form.

clrscrn

Clears the screen.

exit

Exits to the configuration level.

remove all

Removes all entries from the ARP cache.

remove ip <IP address>

Removes an entry from the ARP cache.

<ip address> = address of the entry being removed.

show cache

Displays the ARP cache table.

show history

Displays the last 20 commands entered during the current CLI

session.

write

Stores the current configuration in permanent memory.

bridge 1 (config-bridge:br0) level commands

bridging mac address <hexadecimal>

Sets the Bridging MAC Address.

Each byte is represented by two adjacent hex digits.

Bytes may run together or be separated by optional punctuation:

123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc

Note that quotes must enclose the value if it contains spaces.

clrscrn

Clears the screen.

exit

Exits to the config level.

no bridging mac address

Removes the Bridging MAC Address.

show

Displays the current configuration.

show history

Displays the last 20 commands entered during the current CLI

session.

show statistics

Show bridge statistics

show status

Show bridge status

state disable

Disables bridging.

state enable

Enables bridging.

write

Stores the current configuration in permanent memory.

choice 1 (config-wlan-choice:wlan0:1) level commands

apply wlan

Try out WLAN settings without saving them to Flash.

If the settings do not work, when you reboot the device,

it will still have the original settings.

clrscrn

Clears the screen.

exit

Exits to the next higher level.

PremierWave EN Command Reference 57

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 211 212

Komentarze do niniejszej Instrukcji

Brak uwag

Lantronix Computer Hardware 900-581 Instrukcja Użytkownika Strona 57

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Lantronix Computer Hardware 900-581