Lantronix MPS100 Przewodnik Instalacji Pobierz pdf (Strona 58)

Local Server Commands Using the Server

6-2

◆ Access controls whether the port is accessible to local equipment (Local), remote users such as a local

printer or dial-out modem (Remote), or both (Dynamic). Dynamic access is used for dial-in/dial-out

modems, or for devices such as teletypes that can be used both interactively and as print devices.

◆ Name sets the port’s name for identification purposes (not to be confused with the username, which

identifies who is using the port).

◆ Password, governs whether the Server password is required for logins.

6.3 Local Server Commands

Each local port can use the following Local mode commands: Logout, and Test Port.

6.3.1 Logout

Obviously, Logout logs out the current port. Any connections to session or services will be disconnected.

6.3.2 Test Port

This command may be used to verify wiring and flow control setup problems with your serial port. The

command sends an identical stream of characters to the terminal, either continuously or for a specified

number of lines. If your connection is regularly dropping characters, you may be able to identify the

problem.

Note: If multisessions are enabled on a port, only that port can issue a Test Port for

itself.

6.4 Status Displays

Three sets of commands can be used to view Server status displays. The Show commands show the current

availability of hosts and services as well as the state of the Server, its ports, and the local services. Monitor

commands provide a continuous display rather than a one-time look. List commands are provided to show

the current setup in permanent memory (that is, the settings that will take effect after the next reboot or

logout).

The List command is a special case, as some displays make no sense to list. Sessions and Users, for

example, have no meaning in the permanent configuration data. List Nodes also has no meaning, as it only

refers to the remote nodes.

Note: Additional keywords apply to some commands; see the Command Reference for

full syntax.

Netstat Shows currently active UDP/TCP/IP and LAT sessions.

Show Nodes Shows the LAT nodes on the network offering services, and their LAT

protocol version. The Status sub-option shows hardware addresses and any

services offered by the node.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 222 223

Brak uwag

Lantronix MPS100 Przewodnik Instalacji Strona 58