Lantronix EDS1100 Podręcznik Użytkownika Pobierz pdf (Strona 29)

4: Installation of EDS2100

EDS1100/2100 User Guide 28

Installing the EDS2100

Be sure to place the device on a flat horizontal or vertical surface. The device comes with

mounting brackets for mounting the device vertically, for example on a wall. If using AC power,

avoid outlets controlled by a wall switch.

Observe the following guidelines when connecting the serial devices:

 The EDS2100 serial ports support RS-232/422/485 devices.

 The null modem cable is the best cable to connect the serial port to another DTE device. The

straight-though (modem) cable is the best cable to connect the serial port to a DCE device.

 Power-up the device by using the Barrel-power connector only. The barrel-power connector

supports a power range of 9 to 30 VDC.

Note: As soon as you plug the device into power, the device powers up automatically,

the self-test begins, and Evolution OS™ starts.

Perform the following steps to install your device which are numbered in Figure 4-7 also.

1. Connect a serial device to your unit.

2. Connect an Ethernet cable between the EDS2100 RJ45 port and your Ethernet network.

3. Plug the EDS2100 into the power outlet by using the power supply that was included in the

packaging. The required input voltage is 9-30 VDC (center +) with1.5W maximum power

required.

4. Power up the serial devices.

TX Serial 2 (green) Blinking—EDS is transmitting data on serial port 2

RX Serial 2 (yellow) Blinking—EDS is receiving data on serial port 2

Diagnostic ON—EDS firmware has completed booting

Blinking 1x/sec—EDS firmware is booting

Blinking 2x/sec—EDS is writing a file to flash

Blinking 4x/sec—EDS is compacting the file system

Blinking 5x/sec— EDS is restoring factory defaults

Table 4-1 EDS2100 LEDs and Descriptions (continued)

LED Description

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 156 157

Brak uwag

Lantronix EDS1100 Podręcznik Użytkownika Strona 29